Instructions For Bathtub Drain Replacement
Introduction
Over time, bathtub drains can become clogged or damaged, causing water to drain slowly or not at all. In some cases, a complete bathtub drain replacement is necessary. This may seem like a daunting task, but with the right tools and instructions, it can be done in a few simple steps.
Tools Needed
Before starting the bathtub drain replacement, these are the tools you will need:
- Adjustable pliers
- Pipe wrench
- Plumbers putty
- New bathtub drain kit
- Teflon tape
- Screwdriver
Step-by-Step Instructions
Follow these steps to replace your bathtub drain:
- Turn off the water supply. Before you start any plumbing work, make sure to turn off the water supply to your bathtub.
- Remove the old drain. Use your adjustable pliers or pipe wrench to remove the old drain from your bathtub. Turn it counterclockwise until it comes loose.
- Clean the area. Once you have removed the old drain, clean the area thoroughly to remove any debris or residue. You may need to use a putty knife to scrape away any old plumbers putty.
- Apply new plumbers putty. Roll a small amount of plumbers putty into a rope shape and place it around the flange of your new drain. This will create a watertight seal when you install the new drain.
- Install the new drain. Place the new drain into the hole in your bathtub and turn it clockwise until it is tight. Use your pipe wrench to tighten it further if necessary.
- Attach the overflow cover. Use your screwdriver to attach the overflow cover plate to your bathtub. This will cover the overflow drain and complete the installation.
- Test the drain. Once you have installed the new drain, turn the water supply back on and test the drain to make sure it is working properly.
Conclusion
Replacing your bathtub drain may seem like a difficult task, but with the right tools and instructions, it is a simple DIY project. By following these step-by-step instructions, you can replace your bathtub drain and enjoy a fully functioning bathtub once again.